Reloading Equipment
A look at the press and process behind every box of Mullet Bullets ammo.
Mark 7 Titan
We run all of our reloading on a Mark 7 Titan — a commercial-grade, servo-driven press built for high-volume, consistent output. Independent motors drive the shell plate, drive mechanism, and primer disk, with an adjustable stroke and a 12-station toolhead.
Because the whole press is automated and motor-controlled rather than hand-cycled, we're able to hold tight, repeatable tolerances on both of the calibers we load, batch after batch.
What Makes The Titan Different
The Titan trades a hand-pulled lever for independent servo motors and a bigger toolhead — built for commercial-scale, repeatable output.
What This Means For Your Ammo
Every case runs the exact same ten steps, so round-to-round variation stays low.
A dedicated powder check station flags charges before a bullet ever gets seated.
We only load 9mm and .223, so the press stays dialed in instead of switching setups all day.
Finished ammo gets a visual check before it's boxed and shipped out.